Stainless steel mailbox Designer HL-B with house number rear light - INDIVIDUAL

Stainless steel mailbox Designer HL-B with house number, rear light - individually with a bell - intercom & camera

Stylish stainless steel letterbox completely made of stainless steel V2A 1.4301, polished with backlit house number. The house number is always clearly visible at night. No rivets or screws are visible. This letterbox is manufactured at Briefkasten Manufaktur. Made in Germany, Bad Salzuflen.

• Designer stainless steel flush-mounted letterbox made of 2 mm stainless steel V2A 1.4301, polished. Optionally also available as surface-mounted variant.
• Front-side mail removal metre 240 mm x 300 mm, to be opened from top to bottom. Incl. 2 keys with key number.
• Post insertion from the front, dimensions insertion: W 24 cm x H 3.5 cm, C4 high.
• From now on with built-in damping elements, these allow the insertion flap to close slowly and quietly.
• House number approx. 70mm high (max. 3 digits) with power-saving LED lighting 12V DC approx. 50mA / 1W, white.
• Optional exchangeable nameplate made of stainless steel with laser inscription or nameplate made of Plexiglas.
• Preparation (built-in speaker not included) for intercom possible.
• Optional preparation (camera not included) for a camera.
• 8-12V DC short-stroke bell push button with LED ring illumination (blue, white, red or green). The illumination of the bell push button cannot be supplied via the control unit. It must be connected to an additional power supply 8-12 V DC.
• Optional 8-12V DC short-stroke light button with pictogram is possible.
• Incl. EVN LED power supply unit / transformer IP65 12V/DC 0.1-4W for the LED lighting (house number, bell push button and name plate if selected).
• Size of flush-mounted or surface-mounted box: H 710 mm x W 310 x D 100 | 150 mm. Flush-mounted box with pre-punched cable inlets and fixing points on all sides. Surface-mounted box for wall mounting with perforation on the back, surface-mounted box for fence mounting without perforation (must be provided by customer). ATTENTION: The front panel of the surface-mounted box also protrudes by 2 cm.
• Plaster box made of steel, galvanised. Surface-mounted box made of stainless steel V2A, ground on all sides without visible screw connection.
• Plaster box with pre-punched cable inlets on all sides.

Important information

Camera or intercom preparation

We recommend that the electrical installation is always carried out by an electrician

We offer the preparation of cameras & microphone units from various manufacturers for our letterboxes. The preparation does not include any end devices, it is the provision of the screw mounts, holes & perforations. So that you can mount your end unit without any problems.

Water protection

For optimal water protection of your mail, the letterbox or letterbox system should, if possible, be located under a canopy.

The mail is only protected from water if it is completely deposited in the box and the access flap is closed. Mail that is not fully inserted allows moisture and dirt to penetrate the letterbox. It is therefore necessary to plan sufficiently dimensioned letterboxes for the upcoming demand. In certain extreme weather conditions, water may nevertheless enter (according to DIN EN 13724 up to 1ccm). This is not a reason for complaint.