Stainless steel mailbox Designer HL-B with house number back illuminated - RAL of your choice - INDIVIDUAL

Stainless steel mailbox Designer HL-B with house number back illuminated - RAL of your choice - individually

Stylish stainless steel mailbox complete made of stainless steel V2A 1,4301, powdered in RAL fine structure matt with rear lights. The house number is always clearly visible at night. There are no rivets or screws visible. This mailbox is manufactured with the Briefkasten Manufaktur. Made in Germany, Bad Salzuflen.

• Designer stainless steel plastering letter made of 2 mm stainless steel V2A 1.4301, powdered in RAL fine structure matt. Optionally also as a wall-mounted variant.
• Fronts side post-withdrawal door 240 mm x 300 mm, to open from top to bottom. Including 2 key with key number.
• Settling from the front, dimensions of: W 24 cm x H 3.5 cm, C4 high.
• from now on with built-in damping elements, which let the throw-in flap slowly and quietly close.
• House number approx. 70mm high (max. 3-digit) with power-saving LED lighting 12V DC approx. 50mA / 1W, white.
• Optionally interchangeable name tag made of stainless steel with laser lettering or name tag made of plexiglass.
• Preparation (installation speaker not included) for intercom.
• Optional preparation (not included in the scope of delivery) for a camera.
• 8-12V DC Kurzhub bell button with LED ring lighting (blue, white, red or green). The lighting of the bell button cannot be supplied by the control unit. It must be connected to an additional power supply 8-12 V DC.
• Optional is an 8-12V DC short-lived light button with pictogram.
• Incl. EVN LED system/Trafo IP65 12V/DC 0.1-4W for the LED lighting (house number, bell button and name tag if selected).
• Dimensions Built-in- or wall-mounted box: H 710 mm x W 310 x D 100 | 150 mm. Built-in box with pretzled cable inlets and fastening points on all sides. Wall-assembled box for wall assembly with hole in the back, wall-mounted box for fence mounting without perforation (must be done on site). Attention, even with wall-mounted boxes, the front cover 2 cm is all over again.
• Steel cleaning box, galvanized. wall-mounted box made of stainless steel V2A, all sides grinding without visible screw connection.
• plastering box with pretzled cable inlets on all sides.

important information

camera or voice center preparation

We always recommend the electrical installation to be carried out by an electrical installer.

We offer the preparation of cameras & speakers from different manufacturers for our mailboxes. The preparation does not contain any end devices, which are the provision of the screw recordings, bores and perforations. So that you can easily install your device.

water protection

To achieve optimal water protection of your post, should be the mailbox or the mailbox system under a canopy .

The post office is only protected from water if it is completely stored in the box and the throw-in flap is closed. Unskined mail enables the penetration of moisture and dirt into the mailbox. It is therefore necessary to plan sufficiently dimensioned mailboxes for the upcoming need. In certain extreme weather conditions, water can still occur (according to DIN EN 13724 to 1ccm). This is not a reason for complaint.